new pulsar 125 Workshop-manual : Page 140

          14. REAR CARRIER/REAR FENDER/
      EXHAUST MUFFLER                                                                       Pulsar     CK   125

 SERVICE INFORMATION...................... 14-1             REAR FENDER.......................................14-2
 REAR CARRIER ...................................... 14-2   EXHAUST MUFFLER............................14-3



  SERVICE INFORMATION
  GENERAL INSTRUCTIONS
  · When removing the rear carrier, be careful not to twist or kink the wires and cables to avoid
    shorted circuit.
  · The exhaust muffler must be removed when it is cold to avoid burns.
  · After installation, make sure that the taillight and turn signal lights operate properly.
  · When installing the exhaust muffler, first tighten the exhaust muffler joint lock nuts and then
    tighten the rear fork pivot nut.


  TORQUE VALUES
  Rear carrier lock bolt                              3.04.0kg-m
  Rear fork pivot nut                                 5.56.5kg-m
  Exhaust muffler joint lock nut                      0.81.2kg-m




14-1