14. HYDRAULIC BRAKE STRYKER 125/150 BRAKE SYSTEM BLEEDING Connect a transparent hose to the bleed valve and fully apply the brake lever after continuously pull it several times. Then, loosen the bleed valve nut to bleed air from the brake system. Repeat these steps until the brake system is free of air. When bleeding air from the brake system, the brake fluid level should be kept over 1/2 of the brake reservoir height. Brake Lever Bleed Valve BRAKE PAD/DISK BRAKE PAD REPLACEMENT Bolts Remove the two bolts attaching the brake caliper holder. The brake pads can be replaced without removing the brake fluid tube. Remove the brake caliper. Remove the brake pad pin bolt caps and then remove the pad pin bolts and brake Brake Caliper pads. Pin Bolts 14-5