9. DRIVE AND DRIVEN PULLEYS/ KICK STARTER AGILITY 50 Check the driven face for wear or damage. Measure the driven face O.D. Service Limit: 33.94mm replace if below Check the movable driven face for wear or damage. Measure the movable driven face I.D. Service Limit: 34.06mm replace if over Inner Bearing DRIVEN PULLEY FACE BEARING REPLACEMENT Drive the inner needle bearing out of the driven pulley face. Discard the removed bearing and replace with a new one. Remove the snap ring and drive the outer Snap Ring bearing out of the driven face. Outer Bearing Bearing Remover Apply grease to the outer bearing. Drive a new outer bearing into the driven face with the sealed end facing up. Seat the snap ring in its groove. Pack all bearing cavities with 5.05.6g grease. Specified grease: Heat resistance 230°C 9-11