Choose your country
We work in partnership with many official Kymco dealers around the world.
You can select the country of your choice from the list below, whatever your choice, we can deliver worldwide!
16. INSTRUMENT/SWITCHES/LIGHTS AGILITY RS 50 NAKED
INSTALLATION
The installation sequence is the reverse of
removal. Fuel Unit
· Install the fuel unit at the connect
position.
OIL METER
INSPECTION
Remove the met-in box. ( 12-4)
Remove the frame body cover. ( 12-4)
Disconnect the oil meter wire connectors
and remove the oil meter. Keep the oil Wire Connector
meter float at the lower position.
Measure the resistances between the wire
terminals as and shown in the left
figure.
Oil Meter
G/R G
Wire Terminals Resistance B
B
Green/Red(+)Black(-) 46
Green(-)Black(+)
Before removing the oil meter, be sure
to drain the motor oil and do not allow Float
sparks or flames near the working area.
Oil Meter Operation Inspection
Connect the oil meter wire connectors and
turn the ignition switch ON.
Measure the resistance between the wire
terminals with the float at upper position.
Green/Red(+)Black(-) About 300
Light Light
OFF
Before performing the following test, Light ON
4.5
operate the turn signals to determine
that the battery circuit is normal.
Move the oil meter float up and down to see Oil Indicator
if the oil indicator light will go out and come Light
on.
If the oil indicator light does not light,
check for burned bulb, loose wire or
connector. After correction, check again
according to the method mentioned
above.
16-3