grand dink 125 mmc Workshop-manual : Page 197

          14.STEERING HANDLEBAR/FRONT WHEEL/FRONT
   BRAKE/FRONT SHOCK ABSORBER/FRONT FORK                               GRAND DINK 125/150



 Connect the front stop switch wire connector.
 Install the handlebar covers. ( 2-6)




 BRAKE FLUID REFILLING                              Stop Switch Wire Connector
 Keep the handlebar upright and remove the
 brake reservoir cover and diaphragm.
 Add DOT-4 brake fluid to the brake
 reservoir.
 · When bleeding, be careful not to allow
     air in the brake reservoir flowing into
     the brake system.
   · When using a brake bleeder, follow the
     manufacturer`s instructions.
   · Never use dirty or unspecified brake
     fluid or mix different brake fluids be-
     cause it will damage the brake system.
 BRAKE FLUID BLEEDING
 Keep the handlebar upright and remove the
 brake reservoir cover and diaphragm. Add
 the specified brake fluid to the upper limit.
 · Do not allow dust or water to enter the
     brake system during refilling.
   · When servicing the brake system, use
     shop towels to cover plastic parts and
     coated surfaces to avoid damage
     caused by splash of brake fluid.
 In order to avoid spilling brake fluid, connect
 a transparent hose to the bleed valve.
   Warning
    Brake fluid spilled on brake pads or
    brake disk will reduce the braking effect.
    Clean the brake pads and brake disk with
    a high quality brake degreaser.
 Fully apply the brake lever and then loosen
 the brake caliper bleed valve to drain the
 brake fluid until there is no air bubbles in the
 brake fluid. Then, tighten the bleed valve.
 Repeat these steps until the brake system is
 free of air.
                                                             Bleed Valve
                                                                                 14-10