8. DRIVE AND DRIVEN PULLEYS K-XCT 125i Boss INSTALLATION Apply lubricant to the drive face boss inner surface, then install the movable drive face assembly. Movable Drive Face Assembly Clutch Outer/Driven Pulley Assembly Install the clutch outer onto the driven pulley assembly. Compress the driven pulley assembly by hand, then install the drive belt into the driven pulley assembly. The drive belt should be installed so that the arrows on the drive belt periphery point in the normal turning direction if the drive belt has arrow mark. Drive Belt The drive belt contact surface of the driven face should be thoroughly cleaned. Install the driven pulley assembly/clutch outer and drive belt together. Use the special tool to hold clutch outer, then tighten the nut to the specified torque. Torque: 5.0~6.0kgf-m (50 ~60N-m) Special tool: Universal holder A120E00017 A120E00056 Nut Universal Holder 8-7