19. STARTING SYSTEM K-XCT 125i START RELAY INSPECTION Release the rubber cap (1) and remove the nut (2), then disconnect the start motor cable. Turn the ignition switch to "ON"position. Squeeze and hold the brake lever fully then push the starter switch. The coil is normal if the start relay switch clicks. Release the rubber caps and remove the nuts, then disconnect the start motor cable, battery (2) (1) positive cable and harness wire. Disconnect the start relay connector and then remove start relay. (3) Connect a fully charged 12 V battery positive wire to the relay switch Yellow/Red wire terminal and negative wire to the Green/Yellow wire terminal. There should be continuity between the cable terminals while the battery is connected, and no continuity when the battery is disconnected. 19-5