1. GENERAL INFORMATION K-XCT 125i Protect wires and harnesses with electrical Do not squeeze wires against the weld or tape or tube if they contact a sharp edge or its clamp. corner. Do not pull too tight After clamping, check each harness to make sure that it is not interfering with any When rubber protector cover is used to moving or sliding parts. protect the wire harnesses, it shall be installed securely. When fixing the wire harnesses, do not make it contact the parts that will generate high heat. Do not break the sheath of wire. If a wire or harness is with a broken sheath, repair by wrapping it with protective tape or replace it. Route wire harnesses to avoid sharp edges or corners. Avoid the projected ends of bolts and screws. Route wire harnesses passing through the When installing other parts, do not press or side of bolts and screws. Avoid the squeeze the wires. projected ends of bolts and screws. No Contact After routing, check that the wire harnesses are not twisted or kinked. Route harnesses so they are neither pulled tight nor have excessive slack. Do not press or squeeze the wire 1-5