16. BATTERY/CHARGING SYSTEM/ A.C. GENERATOR MXU 250R/300R Flywheel Nut Hold the flywheel with a flywheel holder and remove flywheel nut and wash. Special tool: Flywheel holder E021 Flywheel Holder Flywheel Puller Remove the flywheel with a flywheel puller. Special tool: Flywheel puller E003 INSTALLATION Reverse the "REMOVAL" procedures. Install the flywheel, washer and tighten the nut. Torque: 6 kgf-m (60 Nm, 43 lbf-ft) Key Before installation, check and make sure that the inside of the flywheel is not contaminated. Make sure install the flywheel onto the crankshaft by aligning the key on the crankshaft with the groove in the flywheel. Install the oil through guide and spring. Install the A.C. generator onto the right crankcase cover and tighten the bolts. Groove Washer Torque: 0.9 kgf-m (9 Nm, 6.5 lbf-ft) Install the right crankcase cover. 16-8