8. DRIVE AND DRIVEN PULLEYS/ V-BELT People GT 300i Install the movable driven face onto the driven face. Grooves Apply grease to the guide rollers and guide roller pins and then install them into the holes of the driven face. Install the seal collar. Remove any excessive grease. · Be sure to clean the driven face off any grease. Set the driven pulley assembly, driven face spring and clutch assembly onto the clutch Guide Pins spring compressor. · Align the flat surface of the driven face with the flat on the clutch drive plate. Compress the tool and install the drive plate nut. Clutch Spring Compressor Set the tool in a vise and tighten the drive plate nut to the specified torque. Torque: 75 N-m · Be sure to use a clutch spring compressor to avoid spring damage. Special Lock Nut Wrench Clutch/Driven Pulley Clutch Spring CompressorE053 Fittings & Nut Wrench, 41mm E033 8-11