agility city 50 Workshop-manual : Page 106

          9. DRIVE AND DRIVEN PULLEYS/
   KICK STARTER                                       AGILITY CITY 50
 Check the driven face for wear or damage.
 Measure the driven face O.D.
 Service Limit: 33.94mm replace if below
 Check the movable driven face for wear or
 damage.
 Measure the movable driven face I.D.
 Service Limit: 34.06mm replace if over




                                                   Inner Bearing
 DRIVEN PULLEY FACE BEARING
 REPLACEMENT
 Drive the inner needle bearing out of the
 driven pulley face.
 Discard the removed bearing and replace with
 a new one.




 Remove the snap ring and drive the outer         Snap Ring
 bearing out of the driven face.




                                                   Outer Bearing
                                                  Bearing Remover
 Apply grease to the outer bearing.
 Drive a new outer bearing into the driven face
 with the sealed end facing up.
 Seat the snap ring in its groove.
  Pack all bearing cavities with 5.05.6g
    grease.
    Specified grease: Heat resistance 230°C




9-11