11. FRONT WHEEL/SUSPENSION/ STEERING Pulsar CK 125 Steel Balls Top Cone Race Apply grease to the top and bottom ball races and steel balls. Install 21 steel balls each on the top and bottom ball races. Install the steering stem into the steering head pipe and then install the top cone race and the bearing adjusting nut. Steering Stem Tighten the bearing adjusting nut until it seats against the top cone race, then turn it back 1/8 turn. Check that the steering stem rotates freely and that there is no vertical play. Steering Stem Wrench Install the front fork. (Refer to 11-14.) Install the upper fork bridge, washer and steering stem nut. Tighten the steering stem nut. Torque: 6.09.0kg-m Properly adjust the installed front fork. (Refer to 11-14.) Lock Nut Wrench, 30x32mm 11-16