1. GENERAL INFORMATION Pulsar CK 125
TROUBLESHOOTING
ENGINE WILL NOT START OR IS HARD TO START
Inspection/Adjustment Symptom Probable Cause
Check if fuel reaches
carburetor by loosening
drain screw Empty fuel tank
Clogged fuel line between fuel
tank and carburetor
Clogged float valve
Fuel reaches Fuel does not Clogged fuel filter
carburetor reach carburetor Clogged fuel tank cap breather
hole
Clogged auto fuel valve strainer
Remove spark plug and Clogged fuel valve passage
install it into spark plug Clogged carburetor air balance
cap to test spark by tube
making it contact the
engine Faulty spark plug
Fouled spark plug
Faulty CDI unit
Spark jumps Weak or no spark Faulty pulser coil
Faulty exciter coil
Faulty ignition switch
Broken or shorted ignition coil
wire
Test cylinder compression
Faulty or slipping clutch
Valve clearance too small
Normal Low or no Valve stuck open
compression compression Worn cylinder and piston rings
Leaking cylinder head gasket
Start engine by follow-
ing normal starting
procedure
Faulty choke control system
Engine does not Engine fires but Leaking intake manifold
fire does not start Incorrect ignition timing
Incorrectly adjusted air screw
Remove spark plug and
inspect again
Flooded carburetor
Dry spark plug Wet spark plug Throttle valve excessively open
Clogged air cleaner
1-16