11. CRANKCASE/CRANKSHAFT People GT 125i SERVICE INFORMATION GENERAL INSTRUCTIONS · This section covers crankcase separation to service the crankshaft. The engine must be removed for this operation. · When separating the crankcase, never use a driver to pry the crankcase mating surfaces apart forcedly to prevent damaging the mating surfaces. · When installing the crankcase, do not use an iron hammer to tap it. · The following parts must be removed before separating the crankcase. Cylinder head Cylinder/piston (chapter 7) Drive and driven pulley (chapter 8) A.C. generator/starter clutch (chapter 10) Rear wheel/rear shock absorber (chapter 16) Starter motor (chapter 19) Oil pump (chapter 4) SPECIFICATIONS Part Item Standard (mm) Connecting rod big end side clearance 0.150.35 Crankshaft Connecting rod big end radial clearance 00.008 TORQUE VALUES Crankcase bolt 1.0 kgf-m Cam chain tensioner slipper bolt 1.0 kgf-m TROUBLESHOOTING Excessive engine noise · Excessive bearing play · Excessive crankpin bearing play · Worn piston pin and piston pin hole 11-2