agility 50 2 Workshop-manual : Page 131

          12. FRONT WHEEL/FRONT BRAKE/
     FRONT SUSPENSION                                                     AGILITY 50

 HYDRAULIC BRAKE (FRONT BRAKE)                      Upper Limit
 Brake Fluid Replacement/Air Bleeding
 Check the brake fluid level on level ground.

   · When operating the brake lever, the
     brake reservoir cap must be tightened
     securely to avoid spill of brake fluid.
   · When servicing the brake system, use
     shop towels to cover plastic parts and
     coated surfaces to avoid damage
     caused by spill of brake fluid.

                                                    Lower Limit



 Brake Fluid Bleeding                                 Bleed Valve
 In order to avoid spill of brake fluid, connect
 a transparent hose to the bleed valve.
  Warning
   Brake fluid spilled on brake pads or
   brake disk will reduce the braking
   effect. Clean the brake pads and brake
   disk with a high quality brake degreaser.
 Fully apply the brake lever and then loosen
 the brake caliper bleed valve to drain the
 brake fluid until there is no air bubbles in the
 brake fluid. Then, tighten the bleed valve.
 Repeat these steps until the brake system is       Front Brake Caliper
 free of air.

 Brake Fluid Refilling
 Add DOT-4 brake fluid to the brake
 reservoir.
 · When bleeding, be careful not to allow
     air in the brake reservoir flowing into
     the brake system.
   · When using a brake bleeder, follow
     the manufacturer`s instructions.
   · Never use dirty or unspecified brake
     fluid or mix different brake fluids be-
     cause it will damage the brake system.
 Make sure to bleed air from the brake system.




                                                                               12-10