kxr maxxer 250 300 Workshop-manual : Page 192

          14. FRONT WHEEL/FRONT SUSPENSION/
   STEERING SYSTEM                                                              ATV 300/250


 INSTALLATION                                                  Holder Surface
 Install handlebar and handlebar holder, then
 tighten the four bolts.

 Torque: 2.3 kgf-m (23 N-m, 16.56 lbf-ft)
 · Align the mark on the handlebar with
     the lower handlebar holder surface.
   · Be sure the upper handlebar holder
     mark face to front.
   · Fist tighten the bolts on the front side
     of the handlebar holder, and then                          Mark
     tighten the bolts on the rear side.
                                                Forward Mark




 Install the handlebar switch by aligning the   Hole
 pin on the handlebar switch with the hole in
 the handlebar and then tighten the two
 screws.




                                                                  Pin
                                                                        "UP" Mark
 Place the right and left brake master
 cylinder on the handlebar and install the
 master cylinder holder with the "UP" mark
 facing up, aligning the punch mark on the
 handlebar with the holder joint seam. First
 tighten the upper bolt and then tighten the
 lower blot.
 Torque: 1 kgf-m (10 N-m, 7.2 lbf-ft)

                                                Punch Mark       Joint Seam
                                                                                    14-16