like 200 i Workshop-manual : Page 117

          12. FUEL SYSTEM                                     LIKE 200i

ECU Module Replacement
When switch is on and battery is connected,
don't remove ECU module, connect additional
wire or cut any wire.
1.Make sure to replace the ECU module after
  the ignition switch is turned off.
2.To identify if new ECU with certain version,
  check with sticker on ECU or with diagnostic
  tool.
3.To aim the axle of throttle at knob of TPS then
  assemble the ECU module and install to
  vehicle.
4.After assembling ECU module, to confirm if
  operating throttle smoothly and throttle back
  in    position    precisely  when      release
  acceleration.
5.Proceeding TPS initial and adaptation setting
  after replacing the ECU module would be
  necessary.
6.Connecting diagnostic tool to the diagnostic
  connector, to check if throttle position and
  output voltage from TPS are out of the range.


    Item               Specification
    TPS Idle (0°)=0.230.05V
   voltage Throttle fully(>90°) = over3.27V



7.To run the engine till reaching the working
  temperature and check with diagnostic tool
  and refer to the related diagnostic report, to
  confirm all figures are fitted in standard.
  (Especially notice if there is any abnormal
  leaking symptom or unstable situation at idle
  speed)




12-11