people 250 s 2 Workshop-manual : Page 83

          6. CYLINDER HEAD/VALVES                                                 PEOPLE/PEOPLE S 250
                                                                         Bolts

 CYLINDER HEAD COVER REMOVAL
 Remove the met-in box, carrier. ( 2-6)
 Remove the body cover, center cover and
 rear fender A. ( 2-6)
 Disconnect the secondary air inlet tube
 connector and breather hose (air cleaner).
 ( 5-2)
 Remove the cylinder head cover four bolts
 and two nuts attaching the secondary air inlet
 duct.
                                                  Cylinder Head Cover                     Nuts
 Remove the cylinder head cover.
                                                      Bolt


 CAMSHAFT REMOVAL
 Turn the A.C. generator flywheel so that the
 "T" mark on the flywheel aligns with the index
 mark on the right crankcase cover.
 Hold the round hole on the camshaft gear
 facing up and the location is the top dead
 center on the compression stroke.
 Remove the cam chain tensioner cap bolt.

                                                  Cam Chain Tensioner              Round Hole
                                                          Tensioner Screw
 Turn the cam chain tensioner screw
 clockwise to tighten it.
 Remove the two bolts attaching cam chain
 tensioner and the tensioner.




                                                                               Bolts
                                                                        Cap Nuts
 First remove the two bolts between the
 cylinder head and cylinder.
 Then, remove the four cap nuts and washers
 on the camshaft holder.

 · Diagonally loosen the cylinder head
     cap nuts in 2 or 3 times.




                                                  Bolts                          Camshaft Holder



                                                                                           6-4