people gt 300 i Workshop-manual : Page 174

Microfiches
Image preview

Page 172

Image preview

Page 173

Image preview

Page 175

Image preview

Page 176

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 224
          14. STEERING HANDLEBAR/FRONT WHEEL/FRONT
    BRAKE/FRONT SHOCK ABSORBER/FRONT FORK                              People GT 300i

                                                            Throttle Cable
  Lubricate the throttle grip front end with
  grease and then install the throttle grip.
  Connect the throttle cable to the throttle grip.
  Install the right and left handlebar switches
  and tighten the screws.

  · Adjust the throttle grip free play to the
      specified range of 26mm.
                                                             Throttle Grip
                                                     Bolt     Collar



  Install the front and rear brake master
  cylinders.

  · Install  the brake master cylinders by
      aligning the index marks.




  FRONT WHEEL
  REMOVAL

  Disconnect the speed wire from the front right
  suspension unit.
  Remove the front axle to pull out the axle.
  Remove the front wheel.



  INSPECTION                                                    Axle
  AXLE RUNOUT
  Set the axle in V blocks and measure the
  runout using a dial gauge.
  The actual runout is  of the total indicator
  reading.
  Service Limit: 0.2 mm replace if over




                                                                   Front axle

14-5