14. REAR WHEEL/SWING ARM/ HYDRAULIC BRAKE ATV 50 HYDRAULIC BRAKE BRAKE FLUID CHANGE/AIR BLEED Screws Place the motorcycle on its main stand on level ground and set the handlebar upright. Remove the two screws attaching the brake fluid reservoir cap. Use shop towels to cover plastic parts and coated surfaces to avoid damage caused by splash of brake fluid. Connect a transparent hose to the brake caliper bleed valve and then loosen the bleed valve nut. Use a syringe to draw the brake fluid out through the hose. Bleed Valve Brake fluid refilling Connect a transparent hose and syringe to the brake caliper bleed valve and then loosen the bleed valve nut. Fill the brake reservoir with brake fluid and use the syringe to draw brake fluid into it until there is no air bubbles in the hose. Then, tighten the bleed valve nut. Torque: 0.6 kgf-m (6 N-m, 4.3 lbf-ft) Brake Reservoir Bleed Valve · When drawing brake fluid with the syringe, the brake fluid level should be kept over 1/2 of the brake reservoir height. · Use only the recommended brake fluid. Recommended Brake Fluid: DOT-4 14-18