super 8 125 Workshop-manual : Page 101

          9. DRIVE AND DRIVEN PULLEYS/
   KICK STARTER                                                              SUPER8 125
 Install the drive pulley face, starting ratchet
 and drive face nut.
                                                   Drive Pulley Face
 · When installing the drive pulley face,
      compress it to let the drive belt move
      downward to the lowest position so that
      the drive pulley can be tightened.
    · Install the starting ratchet by aligning
      the starting ratchet teeth with the
      crankshaft teeth.



 Hold the drive pulley with the universal                              Starting Ratchet
                                                    Drive Face Nut
 holder and tighten the drive face nut.
 Torque: 5.5kg-m                                   Drive Pulley
  Special
 Flywheel Holder
 Do not get oil or grease on the drive belt
    or pulley faces.




 CLUTCH/DRIVEN PULLEY                                                             Flywheel Holder
 Remove the left crankcase cover.                  Clutch Outer
 Remove the drive pulley and drive belt.
 Hold the clutch outer with the universal
 holder and remove the clutch outer nut.
  Special
 Flywheel Holder




 INSPECTION                                                                      Flywheel Holder
 Inspect the clutch outer for wear or damage.
 Measure the clutch outer I.D.
 Service Limit: 125.5mm replace if over




9-7