super 8 125 Workshop-manual : Page 58

          5. FUEL SYSTEM                                                                      SUPER8 125

                                                       Auto Bystarter
CARBURETOR REMOVAL
 Remove the frame right side cover. ( 2-4)
 Disconnect the auto bystarter wire
 connector.
 Remove the met-in box. ( 2-3)




                                                     Auto Bystarter Wire

 Loosen the drain screw and drain the fuel
 from the float chamber.
 Disconnect the fuel tube and vacuum tube at
 the carburetor.
 Disconnect the TPS coupler and remove the
 TPS unit




                                                     TPS Unit           Fuel Tube

 Loosen the throttle cable adjusting nut and         Air Cleaner Connecting Vacuum Tube   Intake Manifold
 lock nut, and disconnect the throttle cable         Tube Band                             Band
 from the carburetor.
 Loosen the carburetor intake manifold band
 and air cleaner connecting tube band screws
 and then remove the carburetor.




                                                   Throttle Cable   Adjusting Nut         Lock Nut
 AUTO BYSTARTER
 OPERATION INSPECTION
 Measure the resistance between the auto
 bystarter wire terminals.
 Resistance: 10 max. (10 minutes
 minimum after stopping the engine)
 If the reading is not within the limit, replace
 the auto bystarter with a new one.



                                                                                              5-4