Choose your country
We work in partnership with many official Kymco dealers around the world.
You can select the country of your choice from the list below, whatever your choice, we can deliver worldwide!
4. LUBRICATION SYSTEM ATV 150/125
Lower Level
ENGINE OIL/OIL FILTER
OIL LEVEL
· Place the motorcycle upright on level
ground for engine oil level check.
· Run the engine for 23 minutes and
check the oil level after the engine is
stopped for 23 minutes.
Remove the oil dipstick and check the oil
level with the oil dipstick.
If the level is near the lower level, fill to the Oil Dipstick Upper Level
upper level with the specified engine oil.
OIL CHANGE
Oil Filter Screen Cap
The engine oil will drain more easily
while the engine is warm.
Remove the oil drain plug bolt located on
the bottom of the engine to drain the engine
oil thoroughly.
After the oil has been completely drained,
Install the oil drain plug bolt.
Torque: 2.5 kgf-m (25 N-m, 18 lbf-ft)
Refer to page 3-2 to clean the engine oil
filter screen oil drain plug bolt
After the oil has been completely drained,
check the filter screen O-ring for damage
and replace if necessary.
Install the oil filter screen, spring and filter
screen cap.
Torque: 1.5 kgf-m (15 N-m, 11 lbf-ft)
Fill with the specified SAE15W40#, API: SG
engine oil to the proper level.
Oil Capacity:
At disassembly:
1 liter (0.88 lmp qt, 1.06 US qt)
At change: Nut/Washer
0.9 liter (0.79 lmp qt, 0.95 US qt)
Check for oil leaks and then start the engine
and let it idle for few minutes.
Recheck the oil level.
OIL PUMP
REMOVAL
Remove the right crankcase cover.
Remove the A.C. generator flywheel.
Special tool:
Flywheel holder E021
Flywheel
Flywheel puller E003
4-3