new pulsar 125 Workshop-manual : Page 92

          10.CRANKCASE/CRANKSHAFT/TRANS-
   MISSION SYSTEM/STARTER SPINDLE                                        Pulsar    CK    125


 CRANKCASE REMOVAL                                                               Bolts
 The following parts must be removed
 before removing the crankcase:
 · Cylinder head (Refer to Section 6.)
 · Cylinder/piston (Refer to Section 7.)
 · Starter motor/generator/left crankcase
   cover/starter clutch/camshaft (Refer to
   Section 8.)
 · Clutch/gear shift mechanism (Refer to
   Section 9.)


 Remove the eleven crankcase attaching
 bolts.                                                   Bolts                Bolts
 Separate the left and right crankcase halves.

 Never pry the crankcase apart with a
    driver to avoid damaging the mating
    surfaces.
 Slightly tap the crankcase to separate the
 crankcase halves using a plastic hammer.




                                                 Gasket               Transmission Fork Shaft
 Remove the gasket and dowel pins.
 Be careful not to lose the washer on the
    gear shift spindle.




                                                                  Dowel Pins



 TRANSMISSION SYSTEM
 REMOVAL
 Remove the transmission fork shaft and
 transmission forks.




                                                                  Transmission Fork

10-3