14. STEERING HANDLEBAR/FRONT WHEEL/FRONT BRAKE/FRONT SHOCK ABSORBER/FRONT FORK PEOPLE/PEOPLE S 250 Throttle Cable Lubricate the throttle grip front end with grease and then install the throttle grip. Connect the throttle cable to the throttle grip. Install the right and left handlebar switches and tighten the screws. · Adjust the throttle grip free play to the specified range of 26mm. Throttle Grip Brake Master Cylinder Install the front and rear brake master cylinders. · Install the brake master cylinders by aligning the index marks. Bolt Bolts Axle FRONT WHEEL REMOVAL Remove the two bolts from the left front absorber. Remove the screw from the speedometer gear unit then disconnect the speed wire from the speedometer gear unit. Remove the front axle to pull out the axle. Remove the front wheel and the speedometer gear unit. Speedometer Gear Unit Screw INSPECTION AXLE RUNOUT Set the axle in V blocks and measure the runout using a dial gauge. The actual runout is of the total indicator reading. Service Limit: 0.2mm replace if over 14-5