Choose your country
We work in partnership with many official Kymco dealers around the world.
You can select the country of your choice from the list below, whatever your choice, we can deliver worldwide!
5. FUEL INJECTION SYSTEM MXU 500EXi/MXU500i
FUEL PUMP
INSPECTIION
Put the side stand up and the engine stop
switch is at "RUN"
F
Disconnect the fuel pump/fuel unit
connector.
Connect the multimeter (+) probe to the
Gray terminal and the multi-meter (-) probe
to the Gray terminal.
Turn the ignition switch to "ON" and
measure the voltage between the terminals.
It should be shown the current battery E
voltage for a few seconds.
If there is still battery voltage, replace the
fuel pump.
If there is not any battery voltage, inspect
the following:
Fuse
Fuel pump relay
ECU
Measure the resistance between the both
Gray.terminals of the fuel pump side
connector.
Standard (at 20°C/68°F): About 10.7
Fuel level sensor inspection
Measure the resistance between the Gay and
Gray terminals of fuel pump side connector.
Standard (at 20°C/68°F):
Float at full position About101
Float at empty position About 3
5-16