zing 125 qe Workshop-manual : Page 149

          17. STARTING SYSTEM                                                               ZING125

                                                      Wire Lock Nut
 STARTER MOTOR
 REMOVAL
 Before removing the starter motor, turn
   the ignition switch OFF and remove the
   battery ground. Then, turn on the
   ignition switch and push the starter
   button to see if the starter motor
   operates properly.


                                                                            Mounting Bolts
                                                           Front Cover
 Remove the starter motor wire lock nut.
 Remove the two starter motor mounting
 bolts and the motor.

 DISASSEMBLY
 Remove the two starter motor case bolts to
 remove the front cover, rear cover,
 commutator, housing and other parts.



                                                  O-ring       Rear Cover          Case Bolts
                                                                            Commutator
 INSPECTION
 Inspect the removed parts.
 Inspect the commutator for wear, damage,
 discoloration and other visual faults. Replace
 if necessary.
 Clean the commutator if there is metal
 powder between the segments.




 Check for continuity between pairs of the
 commutator segments and there should be
 continuity.
 Also, make a continuity check between
 individual commutator segments and the
 armature shaft. There should be no
 continuity.




                                                                                         17-2