14. BATTERY/CHARGING SYSTEM/ A.C. GENERATOR AGILITY CITY 125 Regulator/Rectifier REGULATOR/RECTIFIER MAIN HARNESS CIRCUIT INSPECTION Remove the front covers. ( 2-2) Remove the regulator/rectifier 4P coupler and check for continuity between the wire harness terminals according to the following : Item (Wire Color) Judgment Between battery (red) Battery has and engine ground voltage Between ground (green) Continuity exists and engine ground Between c.d.i wire (black/blue) and engine ground (Remove the auto A.C. generator bystarter coupler and stator nought turn the lighting switch resistance OFF for inspection) Between charging coil A.C. generator (yellow or peach) and stator nought engine ground resistance Black REGULATOR/RECTIFIER REMOVAL Remove the regulator/rectifier lock nut and disconnect the regulator/rectifier wire coupler. Measure the resistances between the regulator/rectifier wire terminals. Replace the Peach Red Yellow Green regulator/rectifier if the readings are not within the specifications in the table below. · Due to the semiconductor in circuit, it (+)Probe is necessary to use a specified tester for Peach Yellow Red Green Black accurate testing. Use of an improper (-)Probe tester or measurements in an improper range may give false readings. Peach 4-7K · Use a Sanwa Electric Tester or Kowa Yellow 4-7K Electric Tester for testing. Testing Range Red Range for the Sanwa Tester: xK Range for the Kowa Tester: x100 Green 4-6K 4-6K 13-17K 1-2K Black 4-7K 4-7K 13-17K 1-2K 14-5