kxr maxxer 250 300 Workshop-manual : Page 218

          16. BATTERY/CHARGING SYSTEM/
    A.C. GENERATOR                                                                     ATV 300/250

                                                                        Lock Lever            Seat
 BATTERY REMOVAL
 Pull right the lock lever and pull up the seat
 at the rear.
 Remove the battery holder, by removing the
 mount bolts. (Make sure the ignition switch
 is oFF)
 Remove the battery by removing the bolt.
 First disconnect the battery negative (-)
 cable and then the positive (+) cable.
   When disconnecting the battery positive
   (+) cable, do not touch the frame with
   tool; otherwise it will cause short circuit
   and sparks to fire the fuel.

                                                   Negative (-) Cable            Positive (+) Cable
 The installation sequence is the reverse of
 removal.
   First connect the positive (+) cable and then
   negative (-) cable to avoid short circuit.




                                                    Bolts                            Battery Holder




 BATTERY VOLTAGE (OPEN CIRCUIT
 VOLTAGE) INSPECTION
 Remove the seat.
 Disconnect the battery cables.
 Measure the voltage between the battery
 terminals.
 Fully charged : 13.1 V
 Undercharged : 12.3 V max
 Battery charging inspection must be
   performed with a voltmeter.




                                                                                              16-4