Choose your country
We work in partnership with many official Kymco dealers around the world.
You can select the country of your choice from the list below, whatever your choice, we can deliver worldwide!
9. DRIVE AND DRIVEN PULLEYS ATV 150/125
Inner Bearing
DRIVEN PULLEY FACE BEARING
REPLACEMENT
Drive the inner needle bearing out of the
driven pulley face.
Discard the removed bearing and replace
with a new one.
Outer Bearing
Remove the snap ring and drive the outer
bearing out of the driven face.
Discard the removed bearing and replace
with a new one.
Apply grease to the outer bearing.
Drive a new outer bearing into the driven face
with the sealed end facing up.
Special tool:
Bearing Puller E008
Seat the snap ring in its groove.
Apply grease to the driven face bore areas.
Pack all bearing cavities with 99.5g
grease.
Specified grease: Heat resistance 230°C
Press a new needle bearing into the driven
face.
Special tool:
Oil Seal And Bearing Install E014 Retainer Plate
CLUTCH DISASSEMBLY
Remove the circlips and retainer plate to
disassemble the clutch.
Keep grease off the clutch linings.
Clutch Lining Circlip
9-10