1. GENERAL INFORMATION MYROAD 700i After clamping, check each wire to make Route harnesses so they are neither sure it is secure. pulled tight nor have excessive slack. Do not pull too tight Do not squeeze wires against the weld or its clamp. Protect wires and harnesses with electrical tape or tube if they contact a sharp edge or corner. After clamping, check each harness to make sure that it is not interfering with any moving or sliding parts. When rubber protecting cover is used to protect the wire harnesses, it shall be installed securely. When fixing the wire harnesses, do not make it contact the parts which will generate high heat. Do not break the sheath of wire. If a wire or harness is with a broken sheath, repair by wrapping it with protective tape or replace it. Route wire harnesses to avoid sharp edges or corners. Avoid the projected ends of bolts and screws. Route wire harnesses passing through the side of bolts and screws. Avoid the When installing other parts, do not press or projected ends of bolts and screws. squeeze the wires. Do not press or squeeze the i 1-5