people 250 s Workshop-manual : Page 134

          10. A.C. GENERATOR/STARTER CLUTCH                                         PEOPLE/PEOPLE S 250

                                                                  Screws                 Screws
 STATOR INSTALLATION
 Install the A.C. generator stator on the right
 crankcase cover and secure it with the three
 bolts.
 Install the pulser coil on the right crankcase
 cover and secure it with the two screws.
 Install the wire grommet in the groove in the
 right crankcase cover securely.
 Be sure to route the stator wire under the
   pulser coil.


                                                  A.C. Generator Stator    Pulser Coil
                                                                                          Gasket
 RIGHT CRANKCASE COVER
 INSTALLATION
 Install the two dowel pins and a new gasket.




                                                                                 Dowel Pins
 Install the right crankcase cover over the                               Right Crankcase Cover
 crankcase, aligning the water pump shaft
 groove with the oil pump shaft.




                                                  Water Pump Shaft               Oil Pump Shaft

 Tighten the nine right crankcase cover bolts.
 Connect the water hoses to the right
 crankcase cover and water pump cover.
 Add the recommended engine oil. ( 4-3)
 Fill the cooling system with the specified
 coolant. ( 3-9)
 · Be sure to bleed air from the water
     jacket after filling the coolant.



10-9