zx scout 50 Workshop-manual : Page 141

          13. STEERINGHANDLEBAR/FRONTWHEEL/FRONT
    BRAKE/FRONTSHOCKABSORBER/FRONTFORK                             ZX / SCOUT 50

                                                     Punch Mark
 Place the brake master cylinder on the
 handlebar and install the holder with "up"
 mark facing up. Be sure to align the
 punch mark with the holder joint.
 First tighten the upper bolt and then tighten
 the lower bolt.
 Torque: 1.01.4kg-m




                                                 Bolts            "Up" Mark



 Install the brake fluid pipe with the
 attaching bolt and two sealing washers.

 Install the handlebar covers. ( 12-3)
 Fill the brake reservoir with recommended
 brake fluid to the upper limit and bleed air
 according to the method stated in 13-9.




 BRAKE CALIPER (FRONT)
 Removal
 Remove the brake caliper. ( 13-10)
 Place a clean container under the brake
 caliper and disconnect the brake fluid pipe
 from the caliper.

   Do not spill brake fluid on any coated
   surfaces.




                                                          Bolt


13-13