ck pulsar 125 Workshop-manual : Page 125

          12. REAR WHEEL/BRAKE/SUSPENSION                                       Pulsar   CK   125


 ASSEMBLY                                          Driver Handle
 Pack all bearing cavities with grease.
 Drive in the left bearing.
 Install the distance collar.
 Drive in the right bearing.
 · Drive in the bearings squarely.
    · Install the bearings with the sealed end
      facing out.




                                                   Drive Chain Gear            Side Collar
 Install the drive chain gear and secure it with
 the snap ring.
 Apply grease to the dust seal and install it to
 the bearing.
 Install the side collar.




                                                                                 Snap Ring

 INSTALLATION
 Install the rear wheel in the reverse order of
 removal.
 · When installing the rear wheel, align
     the groove on the brake panel with the
     tab on the rear fork.
   · After rear wheel installation, be sure to
     adjust the drive chain slack and rear
     brake pedal free play.
 Torque: 6.08.0kg-m


 REAR BRAKE
 REMOVAL
 Remove the rear wheel and rear brake panel.

 INSPECTION
 Measure the rear brake lining thickness.
 Service Limit: 2.0mm replace if below




12-5