ck pulsar 125 Workshop-manual : Page 55

          5. ENGINE REMOVAL/INSTALLATION                                       Pulsar   CK   125

                                                                     Upper Bracket Bolt
 Remove the four front engine bracket lock
 nuts and take out the four bolts to remove the
 engine bracket.
 Remove the engine upper bracket nut and bolt.




                                                                              Front Engine
                                                                              Bracket Bolts

                                                    Rear End Bolts
 Remove the two lock nuts attaching the
 engine rear end.
 First remove the upper bolt to tilt the engine
 forward.
 Then, remove the lower bolt and slightly tilt
 the engine to the left while removing it from
 the right.




 ENGINE INSTALLATION
 Install the engine in the reverse order of
 removal.
 Install the engine to its original position with
 a jack or other adjustable support.
· When installing the engine, do not
     damage the bolt threads and route the
     wires and cables properly.
   · Install the gear shift pedal by aligning
     the punch mark on the pedal with that
     on the spindle.
   · Fill the crankcase to the proper level
     with the recommended engine oil.
   · After installation, perform the following
     inspections and adjustments:
     1. Throttle operation
     2. Clutch lever free play adjustment
     3. Drive chain adjustment




5-3