grand dink 250 Workshop-manual : Page 153

          13. FUEL SYSTEM/CARBURETOR/
    FUEL PUMP/ FUEL TANK                                                GRAND DINK 250


 AUTO BYSTARTER INSPECTION
 /REMOVAL
 AUTO BYSTARTER INSPECTION
 Measure the resistance between the auto
 bystarter wire terminals.
 Resistance: 10 (10 minutes minimum after
              stopping the engine)
 If the reading is not within the limit, replace
 the auto bystarter with a new one.




 Connect a hose to the fuel enriching circuit
 of the carburetor. Connect the auto
 bystarter green/black wire to the positive (+)
 terminal of a battery and black/white wire to
 the negative (-) terminal. Wait 5 minutes
 and blow the hose with mouth. If the              B/W
 passage is blocked, the auto bystarter is
 normal.
 Disconnect the auto bystarter from the
 battery. Wait 30 minutes and blow the
 hose with mouth.. If air can be blown into
 the hose, the auto bystarter is normal.             G/B


                                                                     Hose


                                                   Auto Bystarter           Screws
 AUTO BYSTARTER REMOVAL
 Remove the one set plate screw and set plate
 and then remove the auto bystarter from the
 carburetor body.




                                                                Set Plate


13-11