grand dink 250 Workshop-manual : Page 162

          13. FUEL SYSTEM/CARBURETOR/
    FUEL PUMP/ FUEL TANK                                                  GRAND DINK 250


                                                  Fuel Pump        Outlet Tube     Inlet Tube
 FUEL PUMP INSTALLATION
 Install the fuel pump and secure it with the
 two bolts.
 Connect the fuel pump inlet, outlet and
 vacuum tubes.
 Install the seat, met-in box and frame center
 cover.




                                                 Vacuum Tube               Fuel Strainer


                                                       Fuel Pump                 Outlet Tube
 Measure the fuel pump output.
 Start the engine and disconnect the fuel
 outlet tube and place a clean container under
 the tube to check the fuel output.
 Output: 40cc/1700rpm/10 seconds .




                                                                                 Container


                                                              Fuel Unit    Fuel Vapor Tube
 FUEL TANK REMOVAL
 Remove the floor board. ( 2-4)
 Remove the leg shield . ( 2-5)
 Disconnect the fuel unit wire connector.
 Remove the fuel tube between the fuel tank
 and the fuel filler.
 Disconnect the fuel vapor tube.
 Remove the fuel tank.
 The installation sequence is the reverse of
 removal.


                                                 Fuel Strainer             Tube to Fuel Filler


                                                                                      13-20