myroad700 Workshop-manual : Page 356

Microfiches
Image preview

Page 354

Image preview

Page 355

Image preview

Page 357

Image preview

Page 358

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 250 255 260 265 270 275 280 285 290 295 300 305 310 315 320 325 330 335 340 345 350 355 360 365 370 371
          20. ELECTRIC STARTER                                                       MYROAD 700i

                                                       Starter Relay Switch
STARTER RELAY SWITCH
INSPECTION
Remove the luggage box.

Retracted the side stand.
Turn the ignition switch to "ON" and engine
stop switch on.
Squeeze the rear brake lever fully and push the
starter switch.
The coil is normal if the starter relay switch
clicks.

If you do not hear the switch click. Inspect the
relay switch using the procedure below.




GROUND LINE INSPECTION
Disconnect the starter relay switch connector.
Check for continuity between the Green wire
terminal and ground.

There should be continuity.




                                                     Starter Relay Connector




VOLTAGE INSPECTION
Connect the starter relay switch connector.
Turn the ignition switch ON and engine stop
switch to RUN.

Measure the starter relay switch Yellow/Red
wire terminal and ground.

If the battery voltage appears only when the rear
brake lever is squeezed fully and starter switch
is pushed, the circuit is normal.

                                                    Starter Relay Switch



20-7