people 250 s Workshop-manual : Page 71

          4. LUBRICATION SYSTEM                                                     PEOPLE/PEOPLE S 250


                                                   Pump Cover Hole             Screw
 Install the pump cover by aligning the hole in
 the cover with the dowel pin.
 Tighten the screw to secure the pump cover.
 Make sure that the pump shaft rotates freely
 without binding.




                                                   Dowel Pin
                                                               Arrow Mark      Pump Shaft
 OIL PUMP INSTALLATION
 Install the oil pump and oil separator and
 tighten the two bolts.
 Make sure that the pump shaft rotates freely.
 The arrow of oil pump is upside.




                                                           Bolts                    Oil Pump

                                                             Oil Pump Driven Gear      Circlip
 Install the pump drive chain and driven gear,
 then set the circlip securely on the pump
 shaft.




                                                   Oil Pump Drive chain
                                                                     Bolts
 Install the oil separator cover properly.

 Fit the tab of the separator cover into the
    slit in the separator.

 Install the A.C. generator starter driven gear.
 ( 10-8)



                                                   Oil Separator Cover

                                                                                         4-6