1. GENERAL INFORMATION ATV 150/125 SPECIFICATIONS (MX'er 150) Model No. LA30 Air cleaner type & No Sponge Fuel System ATV Name MX'er 150 8.1 liters (1.7 lmp gal, Fuel capacity Overall length 1600 mm (64 in) 2.11 Usgal) Carburetor Overall width 980 mm (39.2 in) Type PD Overall height 990 mm (39.6 in) Float lever 14.8 mm (0.592 in) Wheel base 1120 mm (44.8 in) Venturi dia. 25 mm (1 in) Engine type O.H.C. Throttle type PISTON Type CDI Electrical Equipment Displacement 149.4 cc (9.1 cu-in) Ignition System Fuel Used 92# nonleaded gasoline Ignition timing 15°BTDC/1700rpm Front wheel 74 kg (162.8 lbs) Contact breaker Non-contact point type Dry weight Rear wheel 78 kg (171.6 lbs) Spark plug (NGK) CR8E Total 152 kg (334.4 lbs) 0.60.7 mm Front wheel 80 kg (176 lbs) Spark plug gap (0.0240.028 in) Gross weight Rear wheel 82 kg (180.4 lbs) Battery Capacity 12V8AH Total 162 kg (356.4 lbs) Clutch type CVT Tires Front wheel 20*7-8 Primary reduction Power Drive System Rear wheel 22*10-8 Helical gear/spur gear system Ground clearance 130 mm (5.2 in) Breaking distance Secondary reduction Perform- 20.6 below Chain drive (m)(ANSI) system ance Min. turning radius (m) 3 Primary reduction ratio 2.8-0.95 Starting system Starting motor Secondary reduction 7.226 Type Gasoline, 4-stroke ratio Cylinder arrangement Single cylinder 26.902 Reverse ratio Combustion chamber type Semi-sphere FR/RR tire rolling 1596/1756 mm Valve arrangement O.H.C., chain drive Moving Device circumference (63.84/70.24 in) 62 x 49.5 mm Bore x stroke 20 kPa (0.2 kg/cm2, 2.84 (2.48 x1.98 in) Front Compression ratio 9.7:1 psi) Tire pressure Compression pressure 1600 kPa (16 kg/cm2, Rear 25 kPa (0.25 kg/cm2, (kg/cm) 227.2 psi) Engine 3.55 psi Intake Open 5.5° BTDC Turning Left 44° Close 27.5° ABDC angle Right 44° Exhaust Open 36° BBDC Rear Disk brake Drum brake Close 4° ATDC Brake system type Front Drum brake Valve clearance Intake 0.06 mm (0.0024 in) Suspension Front Swing Device Damping Exhaust 0.06 mm (0.0024 in) type Rear Swing arm Idle speed 1700 rpm Shock Front Swing Forced pressure & Lubrication System Lubrication type wet sump type Rear Swing arm Oil pump type Inner/outer rotor type Frame type Steel tube type Oil filter type Full-flow filtration Oil capacity 1 liter (0.88 lmp qt, 1.06 US qt) Oil exchanging 0.9 liter (0.79 lmp qt, capacity 0.95 US qt) Cooling Type Air cooling 1-2