3. INSPECTION/ADJUSTMENT ATV 150/125 Cylinder Head Cover VALVE CLEARANCE Inspect and adjust valve clearance while the engine is cold (below 35). Remove the cylinder head cover. Bolts Turn the flywheel counterclockwise so that the "T" mark on the flywheel aligns with the index mark on the crankcase to bring the round hole on the camshaft gear facing up to the top dead center on the compression stroke. Punch Marks Valve Wrench Inspect and adjust the valve clearance. Valve Clearance: IN: 0.06 mm (0.0024 in) EX: 0.06 mm (0.0024 in) Loosen the lock nut and adjust by turning the adjusting nut Special tool: Tappet adjuster E012 · Check the valve clearance again after the lock nut is tightened. CARBURETOR IDLE SPEED Throttle Stop Screw · The engine must be warm for accurate idle speed inspection and adjustment. Warm up the engine before this operation. Start the engine and connect a tachometer. Turn the throttle stop screw to obtain the specified idle speed. Idle Speed: 1700100rpm When the engine misses or run erratic, adjust the air screw. Throttle Stop Screw 3-6