4. LUBRICATION SYSTEM ATV 150/125 Nut Install the pump driven gear and drive chain by aligning the pump driven gear with the cutout in the pump shaft. Install and tighten the pump driven gear nut. Torque: 1 kgf-m (10 N-m, 7.2 lbf-ft) Pump Driven Gear Bolts Install the oil separator cover and tighten the bolts. Oil Separator Cover Dowel Pin Install the starter idle gear. Install starter clutch and washer. Make sure the "INSIDE" mark on the washer facing the right crankcase. Install the nut (Left threaded) and tighten it using the special tool to specified torque. Special tool: Starter Idle Gear Starter Clutch Gasket Lock nut socket wrench E009 Torque: 9.5 kgf-m (95 N-m, 68 lbf-ft) Install the gasket and dowel pins. 4-7