grand dink 250 Workshop-manual : Page 57

          4. LUBRICATION SYSTEM                                                     GRAND DINK 250

                                                   Pump Cover   Hole                Screw
 Install the pump cover by aligning the hole in
 the cover with the dowel pin.
 Tighten the screw to secure the pump cover.
 Make sure that the pump shaft rotates freely
 without binding.




                                                    Dowel Pin

                                                                       Arrow Mark
 OIL PUMP INSTALLATION
 Install the oil pump and oil separator and
 tighten the two bolts.
 Make sure that the pump shaft rotates freely.
 The arrow of oil pump is upside.




                                                                        Bolts
                                                   Pump Drive Chain             Circlip
 Install the pump drive chain and driven gear,
 then set the circlip securely on the pump
 shaft.




                                                                Pump Driven Gear
                                                                       Bolts
 Install the oil separator cover properly.

 Fit the tab of the separator cover into the
    slit in the separator.
 Install the A.C. generator starter driven gear.
 ( 10-5)



                                                          Oil Separator Cover

                                                                                            4-6