super 8 50 2t 1 Workshop-manual : Page 149

           13.STEERING HANDLEBAR/FRONT WHEEL/FRONT BRAKE/FRONT SHOCK
 ABSORBER/FRONT FORK                                                    SUPER8 50 2T


ASSEMBLY
  Clean all removed parts.
  Apply silicon grease to the pistons and oil
  seals. Lubricate the brake caliper cylinder
  inside wall with brake fluid.
  Install the brake caliper piston with grooved
  side facing out.
 Install the piston with its outer end
     protruding 35mm beyond the brake
     caliper cylinder.

                                                  Fixed-Reed

  Wipe off excessive brake fluid with a clean
  shop towel. Apply silicon grease to the
  brake caliper seat pin and caliper inside.
  Install the brake caliper seat.




                                                           Brake Pads



INSTALLATION
  Install the brake caliper and tighten the two
  bolts.
  Torque: 2.93.5kg-m
  Connect the brake fluid tube to the brake
  caliper and tighten the fluid tube bolt.
  Torque: 3.04.0kg-m
  Fill the brake reservoir with recommended
  brake fluid and bleed air from the brake
  system.                                                      Caliper Bolts


FRONT SHOCK ABSORBER
REMOVAL
  Remove the front cover. ( 2)
  Remove the front wheel.
  Remove the front shock absorber upper
  mount bolts.
  Loosen the lower mount bolts to remove the
  front shock absorbers.




                                                                Mount Bolt
13-13