zx scout 50 Workshop-manual : Page 166

          15. ELECTRICAL EQUIPMENT                                                   ZX / SCOUT 50

 PERFORMANCE TEST
 Warm up the engine.
 Remove the floor mat and battery cover.




 Stop the engine and open the fuse box.
 Disconnect the wire lead from the fuse
 terminal. Connect an ammeter between
 the wire lead and fuse terminal as shown.
 Connect the battery positive (+) terminal to
 the voltmeter positive (+) probe and battery
 negative (-) terminal to the voltmeter
 negative (-) probe.
 Start the engine, gradually increase engine
 speed to test the output:
     Position
                    Day            Night
 RPM
    2500         1.3A min.      1.0A min.
    6000         2.0A min.      2.0A min.

 Charging Limit Voltage: 14.50.5V/8000rpm
 If the limit voltage is not within the
 specified range, check the regulator/
 rectifier.



 A.C. GENERATOR (CHARGING
 COIL) INSPECTION

                                                A.C. Generator Connector

 Remove the met-in box. ( 12-4)
 Disconnect the A.C. generator connector.
 Measure the resistances between the
 charging coil terminals (white­green) and
 lighting coil terminals (yellow­green).
 Resistances:
 Charging coil white­green 0.21.2
 Lighting coil yellow­green 0.31.0

 Refer to 7-3 for A.C. generator removal.




15-5