17. LIGHTS/ SWITCHES ATV 150/125 MXU 150: INSPECTION Disconnect the ignition switch connectors. (Refer to the "HANDLEBAR COVER REMOVAL" section in chapter 2.) Check for continuity between the switch side connector terminals in each switch position. Continuity should exist between the color coded wires as right: REPLACEMENT Release the switch wire from the wire clips on the steering shaft holder frame pipe. Remove the handlebar cover (see page 2- 12). Remove the ignition switch from the cover while pushing in the two stoppers. Install a new ignition switch by aligning the locating tab with the groove in the cover. Install the removed parts in the reverse order of removal. STOP SWITCH Disconnect the front stop switch wire coupler. Check for continuity between the front stop switch wires. Brake lever applied: There is continuity. Brake lever released: There is no continuity. 17-6