mxer mxu 150 Workshop-manual : Page 94

          5. FUEL SYSTEM                                                                      ATV 150/125


                                                                          Lock Nut
 CARBURETOR INSTALLATION
 Install the carburetor onto the intake
 manifold and tighten the two lock nuts.
 Torque: 1 kgf-m (10 N-m, 7.2 lbf-ft)
 Install the air cleaner connecting tube and
 tighten the band screw.




                                                           Band Screw
                                                                   Clip        Needle Retainer
 THROTTLE VALVE ASSEMBLY
 Install the jet needle into the throttle valve
 and secure with the needle retainer.
 Jet Needle Notch: 4th Notch
 (Counted from top to bottom)




                                                  Throttle Valve       Jet Needle
                                                     Carburetor Cap                  Spring

 Assemble the rubber cover, carburetor cap
 and throttle valve spring.
 Connect the throttle cable to the throttle
 valve.




                                                      Throttle Valve                Notch
                                                                               Groove
 Install the throttle valve into the carburetor
 body.
 Align the groove in the throttle valve
   with the throttle stop screw on the
   carburetor body.
 Connect the accelerating pump cable.
 Fully open the throttle and adjust the
 accelerating pump cable to align the punch
 mark on the accelerating pump arm with the
 punch mark on the set plate.
                                                    Throttle Stop Screw


                                                                                              5-8