mxer mxu 150 Workshop-manual : Page 99

          6. ENGINE REMOVAL/INSTALLATION                                                     ATV 150/125

                                                        A.C.G. Wire Connector
 ENGINE REMOVAL
 Drain engine oil and transmission oil (refer
 to chapter 3).
 Remove seat, front cover, center cover,
 front fender, rear fender and exhaust muffler
 (refer to chapter 2).
 Remove the carburetor (refer to chapter 5).
 Disconnect the battery negative cable.
 Remove the frame body cover.
 Disconnect the engine negative cable.
 Disconnect the A.C.G. wire connector and
 neutral lamp switch.                            Neutral Lamp Switch

                                                        Starter Relay       Starter Motor Cable
 Disconnect the starter motor cable from the
 starter relay.




                                                 Crankcase Breather hose
 Disconnect the crankcase breather hose
 from the cylinder head cover.
 Disconnect the transmission case breather
 hose from the transmission case.




                                                             Transmission Case Breather hose

                                                               Connecting Tube
 Loosen the drive belt air cleaner connecting
 tube band screw and remove the connecting
 tube.




                                                                           Screw


                                                                                         6-2