grand dink 250 Workshop-manual : Page 219

          19. SWITCHES/HORN/FUELUNIT/THERMOSTATICSWITCH
   /TEMPERATUREGAUGE/INSTRUMENTS/LIGHTS                            GRAND DINK 250

                                                          Wire
 LIGHTS
 HEADLIGHT BULB REPLACEMENT
 Remove the front upper cover. ( 2-5)
 Disconnect the headlight and turn signal light
 wire couplers.
 Remove the rubber boot from the bulb socket.
 Remove the bulb socket and replace the bulb.
 Install the bulb socket, aligning the bulb
 socket tab with the groove.
 Install the rubber boot.
 Install the front cover in the reverse order of             Bulb Socket
 removal.
                                                                   Wire
 FRONT POSITION LIGHT BULB
 REPLACEMENT
 Remove the front upper cover. ( 2-5)
 Disconnect the headlight and turn signal light
 wire couplers.
 Remove the bulb sockets by turning them
 counterclockwise.
 Remove the bulbs and replace them with new
 ones.


                                                   Front Position Light Bulb Sockets
                                                             Screw
 FRONT TURN SIGNAL LIGHT BULB
 REPLACEMENT
 Remove the one screw attaching the turn
 signal light shell and remove the light shell.
 Remove the turn signal fixer two screws.
 Remove the bulb protector screw.
 Remove the bulb and replace with a new one.




 TAILLIGHT/REAR TURN SIGNAL
 LIGHT BULB REPLACEMENT
 Remove the rear protective cover. ( 2-3)
 Remove the two screws attaching the rear
 light shell and remove the light shell.
 Remove the bulbs and replace with new ones.
 The installation sequence is the reverse of
 removal.



                                                              Screws

                                                                                   19-8