grand dink 250 Workshop-manual : Page 48

          3. INSPECTION/ADJUSTMENT                                          GRAND DINK 250


 HEADLIGHT AIM
 Turn the ignition switch ON.
 Turn on the headlight switch.
 Adjust the headlight aim by turning the
 headlight aim adjusting bolt.




                                                   Headlight Aim Adjusting Bolt


 CLUTCH SHOE WEAR
 Start the engine and check the clutch
 operation by increasing the engine speed
 gradually.
 If the motorcycle tends to creep or the engine
 stalls, check the clutch shoes for wear and
 replace if necessary.

 COOLING SYSTEM
COOLANT LEVEL INSPECTION
Place the motorcycle on its main stand on
level ground.
Check the coolant level of the reserve tank         Upper Line
and the level should be between the upper
and lower level lines.
If necessary, fill the reserve tank with
recommended coolant to the "F" level line.
Recommended Coolant: SIGMA Coolant
              (Standard Concentration 30%)
 · The coolant level does not change no
     matter the engine is warm or cold. Fill
     to the "F" (upper) line.
 COOLANT REPLACEMENT
                                                   Lower Line
 · Perform this operation when the engine
      is cold.                                              Radiator Cap
 Remove the front cover.
 Remove the radiator cap.
 Remove the drain bolt to drain the coolant
 and tilt the motorcycle to the right and the
 coolant will drain more easily.
 Drain the coolant in the reserve tank.
 Reinstall the drain bolt.
 Fill the radiator with the specified coolant.
 · The coolant freezing point should be 5
       lower than the temperature of the
      riding area.                                Reserve Tank

3-9